Breaker blocks, explained

Sometimes an order block fails. Price runs the stops beyond an old low, then breaks the other way straight through the block. ICT calls what's left a breaker. It now works from the other side.

IN ONE LINEA bullish breaker: low, high, lower low, then price breaks back above the high. The last up candle at that high becomes support.

6 short lessons · about 4 minutes

What you'll see on the chart · 5-minuteIllustration
  • Before: the up candle at the high
  • After the break: bullish breaker
  • Mean threshold (50%)
  • The low that gets raided

Lesson 1 · Low, high, lower low

A raid, a break, and the candle flips sides

Price takes the stops under an old low, then reverses hard and breaks the high in between. The last up candle at that high was the block that failed. Now it's a breaker.

Bullish breaker, step by stepIllustration
1 · Swing low
Stops rest under it.
2 · Swing high
Mark the last up-close candle at this high. It's the candle that will flip.
3 · Lower low
Price runs below point 1 and takes those stops. That's the raid.
The break
Price trades back above point 2. The candle at 2 is now a bullish breaker.

KEYRaid first, then a break of structure. The candle at the broken high is the breaker.

Lesson 2 · Bullish and bearish

A broken high leaves support, a broken low leaves resistance

The bearish breaker is the mirror: high, low, higher high, then price breaks below the low.

Bullish breaker · support

Low, high, lower low, break above the high. The last up candle at the high is support.

Bearish breaker · resistance

High, low, higher high, break below the low. The last down candle at the low is resistance.

KEYThe breaker sits on the side price broke away from. It's tested from the other side than it formed on.

Lesson 3 · The whole candle

The breaker is the candle's whole range

An order block uses the body. A breaker uses the entire candle, high to low, and its 50% is the mean threshold.

Reading a bullish breaker on the retestIllustration
Top · the high
The near edge. Price reaches it first on the way back.
Mean threshold
The 50% of the whole candle. Wicks may poke past it; watch the closes.
Bottom · the low
The far edge. A body closing below it ends the breaker.

KEYHigh to low, wick to wick. Judge it by where the bodies close.

Lesson 4 · What happens next

Three ways a retest plays out

Each picture is a bullish breaker. For a bearish one, flip them upside down.

Strong

Taps the top and leaves

Price barely reaches the breaker before buyers take over.

Tested · still valid

Deep wick, body holds

A wick goes deep, but the candle closes back above. It has been tested.

Failed · it's over

Body closes through

A body closes below the breaker's low. It no longer counts as support.

KEYA test is not the end. A body closing past the far side is.

Lesson 5 · How to spot one

Four checks, in order

  1. Find three swings: low, high, lower low

    For a bearish breaker: high, low, higher high.

  2. Check the raid

    The third swing must run past the first one. That takes the stops resting there.

  3. Wait for the break

    Price trades back past the middle swing (the high, for a bullish breaker).

  4. Mark the last up candle at that high

    Its whole range is the breaker. Mark the 50% too, and extend them right.

Lesson 6 · Good to know

A few details that change the read

Order block vs breaker

An order block holds from the side it formed on. A breaker is an order block that failed, and now works from the other side.

No lower low? Not a breaker

If the third swing fails to take the first one, ICT calls the same idea a mitigation block.

Wait for a clean close

The break often runs right through the candle. It's cleaner once price has closed beyond it, so you're not reading it mid-move.

In Omen Layers

Omen Layers finds breakers for you, on any timeframe, on one chart.

  • Turn on a BRK row in the sequencer and pick its timeframe, or type 1h breaker in TUNE and press Enter.
  • The Swing knob sets how many candles each side make a swing high or low. Higher means fewer, bigger swings.
  • A new breaker is dimmed until price closes clear of it, then outlined. Once price comes back into it, it reads BRK ✓.
  • It ends when a body closes past its far side. MEAN THR draws the 50% line.
  • The ? beside the row opens a short note like this page.
See Omen Layers →
THE RECAP
  • Low, high, lower low: the lower low raids the stops under the first low.
  • A break above the high turns the last up candle there into a bullish breaker.
  • It's the candle's whole range; its 50% is the mean threshold.
  • A body closing past the far side ends it.
Education only · Not financial advice

Charts on this page are illustrations drawn for teaching. They are not real market data and do not show any product's output. ICT concepts are taught by Michael J. Huddleston; this page is an independent explanation.